Des sieges de S2000 qui se fixent sans problemes sur le MR a priori. Avec 2-3 trous à percer




Thanks guys. The front part of the rails are a direct fit. (Used the s2k rails). My friend had to drill a hole a little further in from the end on the rear part of the rails to secure it down back there. There is also a section near the console that requires drilling. That's the only part we haven't done yet. Otherwise they're in pretty snug.
Sorry about the metal shavings. This pic was taken right after we put them in. Basically just drill a hole a bit further up the rail so it lines up with the hole in the floor. You only need to do this for the rear part of the rail that sits next to the door.

J'aime bien, perso niveau look. Cependant, pour avoir été assis dans une S2000, j'ai trouvé qu'ils sont vachement plus serrés et moins confortables que ceux du MR, mais bon, à voir....
Le post en question: http://spyderchat.com/forums/showthread ... -installed...